Radar Motion Sensor Solar Powered Led Flood Lights Outdoor Aluminum
Wall Light
Specification:
- Product Name: Aluminum triangle Solar Lights
- Solar panels Specifications: 5.5V 3.2W
- Battery: Lithium iron phosphate battery 3.2V 3000mah battery with
charge and discharge protection board
- Battery protection voltage: 2.65-3.75V
- Battery Life: 2000 times charge cycles
- LED quantity: 30 lumens 0.5 watt LED * 48 pcs
- Luminous flux: 800lm luminous flux up to full power
- Housing material: PC + UV UV component
- Sensing modes: Microwave sensor
- Microwave power: 10.8G 2 mW
- Sensing distance: 5-10 meters
- Lighting modes: light control + strong lights when people nearby,
micro-light when people leave,
- Mode Delay time: 15 seconds
- Lighting duration: can induction more than 500 times when full
charged (15 seconds each)
- Charging time: 8 hours full sun off
- Waterproof grade: IP65
weight:630g
size:230*103*83mm
Product Name | Aluminum triangle Solar Lights |
Solar panels | 5.5V 3.2W |
Battery protection voltage | 2.65-3.75V |
Waterproof grade | IP65 |
Sensing distance | 5-10 meters |
Product performance:
★ During the daytime, the system is charging,and the light is turned
off,at night,the system starts lighting automatically
★ Each press of a button will replace a light mode,switch circularly
- power on:press and hold the button for 5-10 seconds to start the
first mode.
- body sensor+micro-mode:when someone comes,the light will
strong,when no one comes,the light will be bright slightly.
- human body induction mode:when someone comes,the light will
strong,when no one comes, the light will turn off
- always light mode:it will always light at night,no induction
function
- emergency light mode:it will be strong light for 30 minutes,and
then turn off the light,the solar panel will time again after
sensing the light.
★ It will work according to the installed mode every day, not need to
switch again.
★ The delay time for a strong light is 15 seconds when someone is
nearby,when in the induction area,the light is always bright, and
when the person leaves the induction area for 15 seconds,the light
enters into the power saving mode
How to use:
Power on:press and hold the switch for 5-10 seconds to enter the
first mode.
Each press on button would change a light mode,switch circularly.
1.Body sensor+micro-mode:dim, full bright for 15 seconds when
motion detected.
2.Human body induction mode:off, full bright for 15 seconds when
motion detected.
3.Always light mode:it will always light at night,no induction
function.
4.Emergency light mode:manual,full bright for 30 minutes.
5.Turn off.
Applications:
1. Mainly used for road, parking lot, stores, roof, expressway,
subway, building.
2. Road toll booth decoration lighting, garden lighting and
square,.
3. at the same time can also be used in street lamps, suitable for
tunnel lighting.
And so on.
Color Temperature:
Details:
